- Install the engine wire harness stay (A) on the bulkhead and fit the engine wire harness on the stay.
- Under the steering gearbox, install the ground cable terminal (A) on the gearbox housing.
- Install the EPS wire harness stay (A) on the gearbox housing and connect the 6P connector (B).
- Centre the steering rack within its stroke and install the left (RHD: right) tie-rod end (A).
- Wipe off any grease contamination from the ball joint tapered section and threads. Then reconnect the tie-rod end (A) to the damper steering arms. Install the ball joint nut (B) and tighten it.
- Install the new cotter pin (C) and bend it as shown (D) or (E).