NOTE: Use fender covers to avoid damaging painted surfaces.
- Write down the frequencies for the radio' s preset buttons. Disconnect the negative (-) cable first, then the positive (+) cable from the battery. Remove the battery.
- Remove the intake air duct (see step 6 on page 5-2).
- Remove the air cleaner housing (see step 33 on page 5-15).
- Disconnect the ground cable (A), then remove the battery tray (B).
- Carefully remove the slave cylinder so as not to bent the clutch line. Do not operate the clutch pedal once the slave cylinder has been removed.
- Disconnect the back-up light switch connector (A), then remove the water pipe bolt (B).
- Disconnect the cables (A) from the cable bracket (B). Carefully remove both cables so as not to bend the cables.
