- Install the water pipe bolt (A), then connect the back-up light switch connector (B).
- Apply Urea Grease UM264 (P/N 41211-PY5-305) to the end of the slave cylinder rod. Install the slave cylinder. Take care not to bend the clutch line.
- Install the battery tray (A), then connect the ground cable (B).
- Install the air cleaner housing (see step 33 on page 5-15).
- Install the intake air duct (see step 6 on page 5-2).
- Install the battery. Connect the positive (+) cable first, then the negative (-) cable to the battery.
- Refill the transmission fluid (see page 13-4).
- Test-drive the vehicle.
- Check the clutch operation.
- Check the front wheel alignment, refer to the 2001 Civic Shop Manual on this CD (see page 18-4).
- Enter the anti-theft code for the radio, then enter the customer's radio station presets.