Special Tool Required
Adjustable ring wrench 07WAA-0010100
- Remove the fuel fill cap.
- Remove the rear seat cushion, refer to the 2001 Civic 3-door Shop Manual on this CD (see page 20-40).
- Remove the access panel (A) from the floor.
- Disconnect the fuel pump 5P connector (B).
- Disconnect the quick-connect fitting (C) from the fuel tank unit.
- Using the tool, loosen the fuel tank unit locknut (A).
- Remove the locknut (A) and the fuel tank unit.
- Remove the stopper (B). Release the hook (C) and remove the strainer case (D), the fuel gauge sending unit (E) and the case (F).
- Install the part in the reverse order of removal with a new base gasket (G) and new O-rings (H), then check these items:
- When connecting the wire harness, make sure the connection is secure and the connector (I) is firmly locked into the place.
- When installing the fuel gauge sending unit, make sure the connection is secure and the connector is firmly locked into place. Be careful not to bend or twist it excessively.
- When installing the fuel tank unit, align the marks (J) on the fuel tank (K) and the fuel tank unit (L).