No Malfunction Indicator Lamp (MIL) Check the ''On Board Diagnostic (OBD) System Check''. Was the OBD System Check performed? YES – Go to step 2. NO – Go to OBD System Check. Check for the following conditions: The meter fuse The ignition feed fuse Is the fuse OK? YES – Go to step 3. NO – Replace the fuse. Turn the ignition switch OFF. Disconnect ECM A connector. Connect the ECM A connector terminal No. 15 and body ground with a jumper wire. Turn the ignition switch ON (II). Is the MIL turn ON? YES – Substitute a known-good ECM and recheck. If symptom/indication goes away, replace the original ECM. NO – Go to step 7.

Turn the ignition switch OFF. Disconnect meter connector. Check for an open in the wire between the ECM A connector terminal No. 15 and meter connector terminal No. 18. Is a problem found? YES – Repair an open in the wire. NO – Go to step 10. Connect the meter connector terminal No. 8 and body ground with a test light. METER CONNECTOR 22P CONNECTOR Wire side of female terminals Turn the ignition switch ON (II). Is the test light turn ON? YES – Go to step 12. NO – Repair an open in the instrument cluster ignition feed circuit. aaa