2-28

Standards and Service Limits

Steering

2-28

Item	Measurement	Qualification	Standard or New	Service Limit
Steering wheel	Rotational play measured at outside edge	With engine running	0-10 mm (0-0.39 in.)	-
	Starting load measured at outside edge	With engine running	29 N (3.0 kgf, 6.6 lbs)	-
Gearbox	Angle of rack guide screw loosened from locked position		20° Max.
Pump	Output pressure with shut-off valve closed	Engine speed at 3,000 rpm (min^-1)	7,600-8,300 kPa (78-85 kgf/cm², 1,110-1,210 psi) 290-1,100 kPa (3-11 kgf/cm², 43-156 psi)
Power steering fluid	Capacity	Use Genuine Honda power steering fluid	For reservoir capacity: 0.3 l (0.32 US qt, 0.26 Imp qt)
			For system capacity: 1.0 l (1.06 US qt, 0.88 Imp qt)
Power steering pump belt NOTE: Adjust a new belt to the new belt spec, run the engine for 5 minutes, then readjust it to the used belt spec.	Deflection with 98 N (10 kgf, 22 lbs) applied mid-way between pulleys		Used belt: 13.0-16.5 mm (0.51-0.65 in.)
			New belt: 9.0-11.0 mm (0.35-0.43 in.)
	Tension (measured with belt tension gauge)		Used belt: 390-540 N (40-55 kgf, 88-121 lbs)
			New belt: 740-880 N (75-90 kgf, 165-198 lbs)

Suspension

Item	Measurement	Qualification	Standard or New	Service Limit
Wheel alignment	Camber	Front	0°00'+45°
		Rear	-0°45'+45'
	Caster	Front	1°33'+1°
	Total Toe	Front	0+3 mm (0+0.12 in.)
		Rear	Adjust: IN 2 +2/-1 mm (0.08 +0.08/-0.04 in.) Inspect: IN 2+3 mm (0.08+0.12 in.)
	Front wheel turning angle	Inside wheel Except 1.7 l engine 1.7 l engine Outside wheel Except 1.7 l engine 1.7 l engine	40°00'+2° 38°00'+2° 31°00' (Reference) 30°00' (Reference)
Aluminium wheel	Runout	Axial	0-0.7 mm (0-0.03 in.)	2.0 mm (0.08 in.)
		Radial	0-0.7 mm (0-0.03 in.)	1.5 mm (0.06 in.)
Steel wheel	Runout	Axial	0-1.0 mm (0-0.04 in.)	2.0 mm (0.08 in.)
		Radial	0-1.0 mm (0-0.04 in.)	1.5 mm (0.06 in.)
Wheel bearings	End play	Front	0-0.05 mm (0-0.002 in.)
		Rear	0-0.05 mm (0-0.002 in.)