Standards and Service Limits

Engine Lubrication

 2-12  

Item Measurement Qualification Standard or New Service Limit
Engine oil Capacity D14Z5, D15Y2, D15Y3, D15Y4 (except KQ, KU), D15Y5, D15Y6, D16W7, D16W8, D16V3, D17A1, D17A2 (except KK, KQ, KU), D17A3, D17A5 (except KN, KY), D17A8, D17Z1 engines 4.2 l (4.4 US qt, 3.7 Imp qt) for engine overhaul
3.5 l (3.7 US qt, 3.1 Imp qt) for oil change, including filter
3.3 l (3.5 US qt, 2.9 Imp qt) for oil change, without filter
D14Z6, D15Y4 (KQ, KU), D16V1, D17A2 (KK, KQ, KU), D17A5 (KN, KY), D17A9 engines 4.2 l (4.4 US qt, 3.7 Imp qt) for engine overhaul
3.2 l (3.4 US qt, 2.8 Imp qt) for oil change, including filter
3.0 l (3.2 US qt, 2.6 Imp qt) for oil change, without filter
Oil pump Inner-to-outer rotor clearance   0.06-0.18 mm (0.002-0.007 in.) 0.20 mm (0.008 in.)
Pump housing-to-outer rotor clearance   0.10-0.18 mm (0.004-0.007 in.) 0.20 mm (0.008 in.)
Pump housing-to-rotor axial clearance   0.02-0.07 mm (0.001-0.003 in.) 0.15 mm (0.006 in.)
Oil pressure with oil temperature at 80°C (176°F) At idle 70 kPa (0.7kgf/cm2, 10 psi) min.
at 3,000 rpm (min-1) 340 kPa (3.5 kgf/cm2, 50 psi) min.

Cooling

Item Measurement Qualification Standard or New Service Limit
Radiator Coolant capacity (Includes engine, heater, hoses and reservoir) M/T: engine overhaul 5.1 l (5.4 US qt, 4.5 Imp qt)
M/T: coolant change 4.0 l (4.2 US qt, 3.5 Imp qt)
A/T, HONDA MULTI MATIC: engine overhaul 5.0 l (5.3 US qt, 4.4 Imp qt)
A/T, HONDA MULTI MATIC: coolant change 3.9 l (4.1 US qt, 3.4 Imp qt)
Reservoir Coolant capacity   0.4 l (0.4 US qt, 0.4 Imp qt)
Radiator cap Opening pressure   93-123 kPa (0.95-1.25 kgf/cm2, 14-18 psi)
Thermostat Opening temperature Begins to open 76-80°C (169-176°F)
Fully open 90°C (194°F)
Valve lift at fully open   8.0 mm (0.31 in.) min.
Radiator fan switch Thermoswitch "ON" temperature   91-95°C (196-203°F)
Thermoswitch "OFF" temperature   Subtract 3-8°C (5-15°F) from actual "ON" temperature

aaa