Seat Belts

Front Seat Belt Replacement (cont'd)

 23-3  

  1. Remove the center pillar upper trim (see page 20-29)
  2. Remove the shoulder anchor adjuster (A).

  1. Install the belt in the reverse order of removal and note these items:
  • If the threads on the retractor mounting self-tapping ET screw are worn out, use an oversized self-tapping ET screw made specifically for this application.
  • Check that the retractor locking mechanism functions (see page 23-5).
  • Assemble the washers, collars and bushing on the upper and lower anchor bolts as shown.
  • Before installing the anchor bolts, make sure there are no twists or kinks in the front seat belt.
  • Make sure the seat belt tensioner connector is plugged in properly.
  • Reconnect the negative cable to the battery.

Upper anchor bolt construction:

  1. UPPER ANCHOR BOLT
  2. UPPER ANCHOR
  3. COLLAR
  4. TOOTHED LOCK WASHER
  5. BUSHING

    Lower anchor bolt construction:

  1. LOWER ANCHOR BOLT
  2. TOOTHED LOCK WASHER
  3. COLLAR
  4. LOWER ANCHOR
  5. SPRING WASHER

aaa