Trim pad remover, Snap-on # A 177 or equivalent, commercially available.
- Remove the inner handle (A). Take care not to scratch the door panel.
- Pry out on the upper portion of the cover (B) to release the hooks (C and D), then remove the cover.
- Remove the screws.
- Pull the inner handle forward and out half-way to release the hook (E).
- Disconnect the inner handle rod (F) and power door lock switch connector (G) (driver's for some models).
Fastener Locations
: Screw, 2
- Remove the switch panel (A).
- Using a flat-tip screwdriver wrapped with protective tape, pry the cap (B), then remove the screw (C).
- Pry out the panel or pocket to release the clips (D).
- Release the clip (E) by pulling the cover or pocket forward.
- Disconnect the power window switch connector (F).
Fastener Locations
C : Screw, 1D 
: Clip, 2 or 1G : Screw, 2
Power window model:
- Remove the screws (G) securing the door panel.
