NOTE:

• Put on gloves to protect your hands.
• When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
• Take care not to bend or scratch the trim and panels.

Remove the trim as shown. To remove the side trim panel, remove the rear seat-back, refer to the '01 CIVIC Shop Manual, P/N 62S5A00 on this CD (see page 20-95).

Install the trim in the reverse order of removal and note these items:

• Before installing the rear shelf, remove the clips from the body and install them to the rear shelf.
• Replace any damaged clips.
• When installing the rear shelf, slip the rear seat belts and centre belt through the slits in the rear shelf.
• Make sure the high mount brake light connector is plugged in properly.

  Fastener Locations

  A : Clip, 9B : Clip, 1C : Clip, 7

  (White)

HIGH MOUNT BRAKE LIGHT CONNECTOR HOOK REAR SHELF REAR CENTRE BELT REAR PILLAR TRIM SLIT REAR SEAT BELT CENTRE PILLAR UPPER TRIM CAP DOOR SILL TRIM FRONT SEAT BELT LOWER ANCHOR BOLTS 7/16 - 20 UNF 32 Nm (3.3 kgf/m, 24 lbf/ft) SIDE TRIM PANEL HOOK HOOKS SLIT CLIP (Three places) HOOK REAR SEAT BELT SLIT