Body

Doors

Component Location Index	20-2
Door Panel Removal/Installation	20-4
Door Outer Handle Replacement	20-5
Door Latch Replacement	20-7
Door Glass and Regulator Replacement	20-9
Door Sash Trim Replacement	20-11
Door Glass Outer Weatherstrip Replacement	20-11
Door Weatherstrip Replacement	20-12
Door Upper Seal Replacement	20-12
Door Side Sill Seal Replacement	20-13
Door Channel Tape Replacement Process	20-14
Door Outer Channel Tape Replacement	20-15

Mirrors

Power Mirror Replacement

20-16

Glass

Component Location Index	20-17
Windshield Replacement	20-18
Rear Window Replacement	20-24
Quarter Glass Replacement	20-29

Interior Trim

Component Location Index	20-33
Trim Removal/Installation-Door Area	20-34
Trim Removal/Installation-Seat Side and Rear Shelf Area	20-35
Trim Removal/Installation-Trunk Area	20-36
Headliner Removal/Installation	20-37

Seats

* Front Seat Disassembly/Reassembly-Passenger's	20-40
Rear Seat-back Lock Cylinder Replacement	20-41
Rear Seat-back Cover Replacement	20-41

Bumpers

Rear Bumper Removal/Installation

20-43

Exterior Trim

Front Grille Replacement	20-44
Rear License Trim Replacement	20-44
Emblem Replacement	20-45

Openers

* Trunk Lid Opener/Fuel Fill door Opener Cable Replacement

20-46

Frame

* Frame Repair Chart

20-48

NOTE: Refer to the '01 CIVIC Shop Manual, P/N 62S5A00 on this CD, for the items not shown in this section.

Outline of 2-door Model Change

The Civic 2-door model has been added.

SUPPLEMENTAL RESTRAINT SYSTEM (SRS) (If body maintenance is required)

This model has an SRS which includes a driver's airbag in the steering wheel hub, a passenger's airbag in the dashboard above the glove box, seat belt tensioners in the front seat belt retractors, seat belt buckle tensioners in the front seat belt buckles and side airbags in the front seat-backs. Information necessary to safely service the SRS is included in the '01 Civic Shop Manual, P/N 62S5A00 on this CD. Items marked with an asterisk (*) on the contents page include or are located near SRS components. Servicing, disassembling or replacing these items will require special precautions and tools and should be done only by an authorised Honda dealer.

To avoid rendering the SRS inoperative, which could lead to personal injury or death in the event of a severe frontal collision, all SRS service work must be performed by an authorised Honda dealer.
Improper service procedures, including incorrect removal and installation of the SRS, could lead to personal injury caused by unintentional deployment of the airbags and/or side airbags.
Do not bump the SRS unit. Otherwise, the system may fail in a collision, or airbags may deploy when the ignition switch is ON (II).
SRS electrical wiring connectors are identified by yellow colour coding. Related components are located in the steering column, front console, dashboard, dashboard lower panel, in the dashboard above the glove box, in the front seats and around the floor. Do not use electrical test equipment on these circuits.