Rear Knuckle Bushing Replacement
Special Tools Required
Bushing driver 30-40 ( 07NAD-SS00100)
or 07NAD-SS00101
| 1. | Position the knuckle (A) on the press with the machined surface (B) facing down.
 CBDA07NAD-SS00100 or
07NAD-SS00101Press |
| 2. | Adjust the special tool so it matches the inner diameter of the bushing hole, then tighten the socket bolts (C) securely.
|
| 3. | Position the special tool on the bushing (D).
|
| 4. | Remove the bushing by pressing on the special tool with a press as shown.
NOTE: Be careful not to damage the inside of the bushing hole while pressing on the bushing.
|
| 5. | Position the knuckle (A) on the press with the machined surface (B) facing up.
 CBDA07NAD-SS00100 or
07NAD-SS00101Press4 ± 0.5 mm |
| 6. | Adjust the special tool so it matches with the outer diameter of the bushing (C).
|
| 7. | Position the special tool on the outer sleeve (D) of the bushing.
|
| 8. | Press the bushing into the knuckle using the special tool as shown.
|
