A/C Refrigerant Oil Replacement (4D with Climate Control)

A/C Refrigerant Oil Replacement

Recommended PAG oil: KEIHIN SP-10

P/N 38897-P13-003: 120 m[liter] (4 fl·oz, 4.2 lmp·oz)
P/N 38898-P13-003: 250 m[liter] (8 1/3 fl·oz, 8.8 lmp·oz)
P/N 38899-P13-A01: 40 m[liter] (1 1/3 fl·oz, 1.4 lmp·oz)

Add the recommended refrigerant oil in the amount listed if you replace any of the following parts.

To avoid contamination, do not return the oil to the container once dispensed, and never mix it with other refrigerant oils.
Immediately after using the oil, reinstall the cap on the container, and seal it to avoid moisture absorption.
Do not spill the refrigerant oil on the vehicle; it may damage the paint; if it gets on the paint, wash it off immediately.

Condenser .	25 m[liter] (5/6 fl·oz, 0.9 lmp·oz)
Evaporator .	45 m[liter] (1 1/2 fl·oz, 1.6 lmp·oz)
Line or hose .	10 m[liter] (1/3 fl·oz, 0.4 lmp·oz)
Recelver/Dryer .	10 m[liter] (1/3 fl·oz, 0.4 lmp·oz)
Leakage repair .	25 m[liter] (5/6 fl·oz, 0.9 lmp·oz)
Compressor .	For compressor replacement, subtract the volume of oil drained from the removed compressor from 130 m[liter] (5 1/3 fl·oz, 5.6 lmp·oz), and drain the calculated volume of oil from the new compressor: 130 m[liter] (5 1/3 fl·oz, 5.6 lmp·oz) - Volume of removed compressor = Volume to drain from new compressor. NOTE: Even if no oil is drained from the removed compressor, don't drain more than 50 m[liter] (1 2/3 fl·oz, 1.8 lmp·oz) from the new compressor.
REMOVED COMPRESSORNEW COMPRESSORSAME LEVEL: ADRAINING VOLUME130 m[liter] (5 1/3 fl·oz, 5.6 lmp·oz)A:

Discharge hose to the compressor (6 x 1.0 mm) : 9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)Compressor bracket to the engine block (10 x 1.25 mm) : 44 N·m (4.5 kgf·m, 33 lbf·t)Discharge hose to the condenser (6 x 1.0 mm) : 9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)Receiver line to the condenser (6 x 1.0 mm) : 9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)Suction hose to the compressor (6 x 1.0 mm) : 9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)Receiver line to the A/C line : 13 N·m (1.3 kgf·m, 9.4 lbf·ft)(1)(2)(3)(4)(5)(6)(7)(8)COMPRESSOR
BRACKETCOMPRESSORDISCHARGE HOSE(3)(1)(2)(7)(8)RECEIVER LINE(4)(5)CONDENSER(6)A/C LINESUCTION HOSECompressor to the compressor bracket (8 x 1.25 mm) : 22 N·m (2.2 kgf·m, 16 lbf·ft)A/C line to the evaporator (6 x 1.0 mm) : 9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)NOTE: LHD type is shown, RHD type is similar.