Emblem/Sticker Replacement (4D)

Emblem/Sticker Replacement

NOTE: When removing the emblems/sticker, take care not to scratch the body.

1.	Clean the body surface with a sponge dampened in alcohol. After cleaning, keep oil, grease, and water from getting on the surface.

Apply the emblem/sticker where shown. When installing the rear i-VTEC sticker on the rear window, align the application tape with the edge of the rear window, and center it, then press the sticker into place, and remove the application tape.

FRONT ''H'' EMBLEMREAR ''H'' EMBLEMACCORD
EMBLEMUnit: mm (in.)Adhesive tapeFRONT
GRILLEPUSH
NUTTRUNK LIDREAR ''H'' EMBLEMADHESIVE TAPECLIPEdge of the trunk lid.Edge of the trunk lid.ACCORD EMBLEM26
(1.02)68
(2.68)18.5
(0.73)18.5
(0.73)Edge of the inner taillight.APPLICATION TAPEi-VTEC STICKERTYPE ''S'' EMBLEM/
REAR EURO EMBLEMREAR ''H'' EMBLEM/ACCORD EMBLEM/REAR EURO EMBLEM: 3M4213E, or equivalent
TYPE ''S'' EMBLEM: 3M4213, or equivalentFRONT ''H'' EMBLEMEdge of the
rear window.ACCORD EMBLEM14.5
(0.57)25.5
(1.0)TYPE ''S''
EMBLEMEdge of the inner taillight.i-VTEC STICKERCenter line69
(2.72)4.0 (0.16)18.5
(0.73)Edge of the trunk lid.6.0
(0.24)ACCORD EMBLEMEdge of the inner taillight.REAR EURO
EMBLEM