Power Steering Hoses, Lines, and Pressure Switch Replacement (HPS)

Power Steering Hoses, Lines, and Pressure Switch Replacement

Note these items during installation:

Connect each hose to the corresponding line securely until it contacts the stop on the line. Install the clamp or adjustable clamp at the specified distance from the hose end as shown.
Check all clamps for deterioration or deformation; replace with the clamps new ones if necessary.
Add the recommended power steering fluid to the specified level on the reservoir and check for leaks.

2.5-5.5 mm
(0.10-0.22 in.)2.0-4.0 mm
(0.08-0.16 in.)2.5-5.5 mm
(0.10-0.22 in.)ADJUSTABLE HOSE CLAMP (A)HOSE CLAMP (B)RETURN LINE FLARE NUT
16 x 1.5 mm
28 N·m
(2.9 kgf·m, 21 lbf·ft)POWER STEERING
PRESSURE SWITCH
12 N·m
(1.2 kgf·m, 8.7 lbf·ft)CYLINDER LINE FLARE NUTS
17 N·m (1.7 kgf·m, 12 lbf·ft)FEED HOSE FLARE NUT
16 x 1.5 mm
42 N·m
(4.3 kgf·m, 31 lbf·ft)PUMP INLET HOSERETURN LINE11 N·m
(1.1 kgf·m, 8.0 lbf·ft)FEED HOSECYLINDER LINE FLARE NUTS
26 N·m (2.7 kgf·m, 20 lbf·ft)ABBAAA