A/T Differential Carrier Bearing Outer Race Replacement
Special Tools Required
Handle driver ( 07749-0010000)
Driver attachment, 78 x 90 mm ( 07GAD-SD40101)
Driver attachment, 72 x 75 mm ( 07746-0010600)
NOTE:
- The bearing and bearing outer race should be replaced as a set.
- Replace the bearing with a new one whenever the outer race is replaced.
- Do not use the thrust shim on the torque converter housing.
- Adjust bearing preload after replacing the bearing and outer race.
- Cost all parts with ATF during installation.
| 1. | Remove the bearing outer race (A), 76.2 mm thrust washer (B), and 76 mm thrust shim (C) from the transmission housing (D) by heating the housing to about 100°C (212°F) with heat gun (E). Do not heat the housing in excess of 100°C (212°F).
NOTE: Let the transmission housing cool to room temperature before installing the bearing outer race.
 ABCDE |
| 2. | Remove the bearing outer race (A) and 80 mm thrust washer (B) from the torque converter housing (C).
 ABC |
| 3. | Install the 80 mm thrust washer and the new bearing outer race in the torque converter housing.
|
| 4. | Drive the bearing outer race to install securely in the housing with the special tools.
 07749-001000007GAD-SD40101 |
| 5. | Install the 76 mm thrust shim (A), 76.2 mm thrust washer (B), and the new bearing outer race (C) in the transmission housing (D).
 CBAD |
| 6. | Drive the bearing outer race in securely so there is no clearance between the outer race, thrust washer, shim and housing with the special tools.
 07749-001000007746-0010600 |
