Secondary Shaft Ball Bearing, Idler Gear Removal and Installation (A/T)

Secondary Shaft Ball Bearing, Idler Gear Removal and Installation

Special Tool Required
Driver attachment, 42 mm I.D. (  07QAD-P0A0100)

Removal

Place a shaft protector (A) on the secondary shaft (B), and set the puller (C) under the idler gear (D), then remove the idler gear and ball bearing (E).

Installation

Install the idler gear (A) on the secondary shaft (B), and install the ball bearing (C) over the idler gear with the special tool and a press.