A/T Shift Solenoid Valves Removal and Installation (A/T)
A/T Shift Solenoid Valves Removal and Installation
NOTE:- Do not hold the shift solenoid connector to remove and to install the shift solenoid valves. Hold the shift solenoid valve body.
- Do not install the shift solenoid valve A before installing the shift solenoid valve D, and do not install shift solenoid valve B before solenoid valve E. If solenoid valves A and B are installed before solenoid valves D and E, it may damage the hydraulic control system.
| 1. | Remove the shift solenoid valves by holding the solenoid valve body. |
| 2. | Install new O-rings (F) on each shift solenoid valves. NOTE: The new shift solenoid valve is equipped with new O-rings. If you install a new shift solenoid valve, there is no need to replace its O-rings.  6 x 1.0 mm12 N·m (1.2 kgf·m, 8.7 lbf·ft)6 x 1.0 mm 12 N·m (1.2 kgf·m, 8.7 lbf·ft)6 x 1.0 mm 12 N·m (1.2 kgf·m, 8.7 lbf·ft)FEFDAFBFC |
| 3. | Install shift solenoid valve D by holding the shift solenoid valve body; be sure to install mounting bracket contacts the servo body. |
| 4. | Install shift solenoid valve A by holding the shift solenoid valve body; be sure to install mounting bracket contacts the bracket on shift solenoid valve D. |
| 5. | Install shift solenoid valve E by holding the shift solenoid valve body; be sure to install mounting bracket contacts the servo body. |
| 6. | Install shift solenoid valve B by holding the shift solenoid valve body; be sure to install mounting bracket contacts the bracket on shift solenoid valve E. |
| 7. | Install shift solenoid valve C by holding the shift solenoid valve body; be sure to install mounting bracket contacts the servo body. |