A/T Clutch Pressure Control Solenoid Valves B and C Replacement (A/T)

A/T Clutch Pressure Control Solenoid Valves B and C Replacement

1.	Disconnect the A/T clutch pressure control solenoid valves B and C connectors.

2.	Remove the A/T clutch pressure control solenoid valves B and C. ADEBC6 x 1.0 mm 12 N·m (1.2 kgf·m, 8.7 lbf·ft)

3.	Remove the ATF joint pipes (D), O-rings (E), and gasket (A).

4.	Clean the mounting surface and fluid passages of the A/T clutch pressure control solenoid valves B and C and transmission housing.

5.	Install the new gasket on the transmission housing, and install the ATF joint pipes.

6.	Install new O-rings over the ATF joint pipes.

7.	Install new A/T clutch pressure control solenoid valves B and C.

8.	Check A/T clutch pressure control solenoid valves B and C connectors for rust, dirt, or oil, then connect the connectors securely.