A/T Housing and Shaft Assemblies Removal
Special Tools Required
Housing puller ( 07HAC-PK40102)
Snap ring pliers ( 07LGC-0010100)
| 1. | Remove the ATF feed pipe (A) from the idler gear shaft, and the ATF lubrication pipe (B) from the transmission housing.
 JFDECBAIGH |
| 2. | Remove the shift solenoid valve cover (C), dowel pins (D), and gasket (E).
|
| 3. | Disconnect the connectors from the shift solenoid valves, and remove the solenoid harness connector (F).
|
| 4. | Remove the mainshaft speed sensor (G) and countershaft speed sensor (H).
|
| 5. | Remove the transmission housing mounting bolts (19 bolts) (I) and transmission hanger (J).
|
| 6. | Align the spring pin (A) on the control shaft (B) with the transmission housing groove (C) by turning the control shaft with the control lever.
NOTE: Do not squeeze the end of the control shaft tips together when turning the shaft.
 CAB07LGC-0010100 |
| 7. | While expanding the snap ring of the secondary shaft bearing using the snap ring pliers, lift the transmission housing. Release the snap ring pliers and remove the transmission housing.
|
| 8. | Remove the countershaft shaft reverse gear and needle bearing.
|
| 9. | Remove the lock bolt securing the shift fork, then remove the shift fork with the reverse selector together.
|
| 10. | Remove the control lever from the control shaft.
|
| 11. | Unlock the detent spring (A) from the detent arm (B).
 AB |
| 12. | Remove the control shaft (A) from the torque converter housing.
 CBA |
| 13. | Turn the detent arm (B) away from the countershaft (C).
|
| 14. | Remove the mainshaft sub-assembly (A), countershaft sub-assembly (B) and secondary shaft sub-assembly (C) together. Do not bump the countershaft on the baffle plate (D).
 ACBD |
| 15. | Remove the baffle plate.
|
| 16. | Remove the differential assembly.
|
