M/T Mainshaft Bearing and Oil Seal Replacement
Special Tools Required
Oil seal driver ( 07JAD-PL90100)
Adjustable bearing puller, 20-40 mm ( 07JAC-PH80100)
Bearing remover shaft ( 07JAC-PH80200)
Slide hammer ( 07741-0010201)
Attachment, 42 x 47 mm ( 07746-0010300)
Driver ( 07749-0010000)
| 1. | Remove the differential assembly.
|
| 2. | Remove the ball bearing (A) from the clutch housing (B) using the special tools.
 07JAC-PH80200AB07741-001020107JAC-PH80100 |
| 3. | Remove the oil seal (A) from the clutch side. Be careful when removing the seal so the clutch housing is not damaged.
 A |
| 4. | Drive the new oil seal in from the transmission side using the special tools.
 07749-001000007746-0010300 |
| 5. | Drive the new ball bearing (A) in from the transmission side using the special tools.
 07JAD-PL90100A |
