M/T Countershaft Bearing Replacement (M/T)

M/T Countershaft Bearing Replacement

Special Tools Required
Oil seal driver (  07JAD-PL90100)

Adjustable bearing puller, 20-40 mm (  07JAC-PH80100)
Bearing remover shaft (  07JAC-PH80200)
Slide hammer (  07741-0010201)

1.	Remove the bearing set plate (A) from the clutch housing (B). AB

2.	Remove the needle bearing (A) using the special tools, then remove the oil guide plate C. C07JAC-PH80100A07741-001020107JAC-PH80200

3.	Position the oil guide plate C and new needle bearing (A) in the bore of the clutch housing (B). 07JAD-PL90100BCA

4.	Install the needle bearing using the special tools.

5.	Install the bearing set plate (A) with bolts (B). B 6 x 1.0 mm 12 N·m (1.2 kgf·m, 9 lbf·ft)A