| 1. | Check the front side frame position, then set the new front side frame and backplate, and align them with the body side front side frame. |
| 2. | Cut the new front side frame and backplate, and clamp them. |
| 3. | Clamp the new front lower cross-member (A), and check the body dimensions, engine compartment, engine compartment and front floor under view, top view, side view. |
| 4. | Tack weld the new front side frame and backplate, and remove the front lower cross-member. |
| 5. | Weld the new front side frame (A) and backplate (B). |
| 6. | Set the new bulkhead upper frame, bulkhead side stay/front lower cross-member and bulkhead side/extension into position, and measure the front compartment diagonally. |
| 7. | Check the body dimensions, engine compartment, engine compartment and front floor under view, top view, side view. |
| 8. | Tack weld the new parts. |
| 9. | Temporarily install the hood, front fender, headlight, and front bumper, then check for differences in level and clearance. |
| 10. | Do the main welding.
|