| 1. | Raise the rear of the vehicle, and support it with safety stands in the proper locations. |
| 2. | Remove the rear wheel. |
| 3. | Place a jack under the lower arm B to support the suspension. |
| 4. | Disconnect the lower arm B from the dumper (A), and the knuckle. |
| 5. | Lower the jack and lower arm B, remove the spring (A), spring mounting rubber (C) and lower spring seat (D). |
| 1. | Install the spring (A), spring mounting rubber (C) and lower spring seat (D) to the lower arm B. NOTE: Align the stopped part (E) of lower spring seat with the stopped part (F) of the lower arm B and with the spring lower end (G). |
| 2. | Place a floor jack under the lower arm B to support the suspension. |
| 3. | Connect the lower arm B and the bottom of the dumper, and the knuckle, then loosely tighten the mounting bolts. |
| 4. | Raise the rear suspension with the jack until the vehicle just lifts off the safety stands, then tighten the damper mounting bolt to the specified torque values. |