Special Tools Required
Bushing driver 30-40 ( 07NAD-SS00100)
| 1. | Position the knuckle (A) on the press with the machined surface (B) facing down. |
| 2. | Adjust the special tool so it matches the inner diameter of the bushing hole, then tighten the socket bolts (C) securely. |
| 3. | Position the special tool on the bushing (D). |
| 4. | Remove the bushing by pressing on the special tool with a press as shown. NOTE: Be careful not to damage the inside of the bushing hole while pressing on the bushing. |
| 5. | Position the knuckle (A) on the press with the machined surface (B) facing up. |
| 6. | Adjust the special tool so it matches with the outer diameter of the bushing (C). |
| 7. | Position the special tool on the outer sleeve (D) of the bushing. |
| 8. | Press the bushing into the knuckle using the special tool as shown. |