Interior Trim Removal/Installation - Rear Shelf Area (4D)

Interior Trim Removal/Installation - Rear Shelf Area

SRS components are located in this area. Review the SRS component locations LHD, SRS components locations RHD and the precautions and procedures in the SRS section before performing repairs or service.

NOTE:

Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Take care not to bend or scratch the trim and panels.

1.	Remove the trim as shown. To remove the high mount brake light, first disconect the bulb socket.

2.	Install the trim in the reverse order of removal, and note these items: Replace any damaged clips. When installing the rear shelf, slip the rear seat belts and center belt through the slits and hole in the rear shelf. Make sure the high mount brake light connector is plugged in properly.

NOTE:

Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Take care not to bend or scratch the trim and panels.

1.	Remove the trim as shown:

Install the trim in the reverse order of removal, and note these items:

If the side curtain airbag have deployed, be sure to check the removed trim pieces for damage before reinstallation, and if necessary, replace them with new ones.
If the side curtain airbag have not deployed, removed trim pieces should still be checked for damage, and replace them with new ones if necessary.
Make sure the top of the trim overlaps with the headliner correctly.
Push the clip portions into place securely.