| DTC P2108: | Throttle Actuator Control Module Problem |
| 1. | Turn the ignition switch ON (II). |
| 2. | Do the DTC CLEAR in the CLEAR MENU with the Honda PGM Tester or the HDS. |
| 3. | Turn the ignition switch OFF. |
| 4. | Turn the ignition switch ON (II). |
| 5. | Check for Temporary DTCs or DTCs in the DTCs MENU with the Honda PGM Tester or the HDS. Is DTC P2108 indicated? YES - Substitute a known-good throttle actuator control module, and recheck. If DTC P2108 is not indicated, replace the original throttle actuator control module .n NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the throttle body, the throttle actuator control module and at the ECM/PCM.n |