| DTC P0122: | TP Sensor A Circuit Low Voltage |
| 1. | Turn the ignition switch ON (II). |
| 2. | Check for Temporary DTCs or DTCs in the DTCs MENU with the Honda PGM Tester or the HDS. Are DTC P0122 and P0222 simultaneously indicated? YES - Go to 9. NO - Go to 3. |
| 3. | Do the DTC CLEAR in the CLEAR MENU with the Honda PGM Tester or the HDS. |
| 4. | Check the TP SENSOR-A in the DATA LIST with the Honda PGM Tester or the HDS. Is there about 0° (REL), 0 % (REL) or 0.3 V when the throttle is fully opened? YES - Go to 5. NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the throttle body and the throttle actuator control module.n |
| 5. | Turn the ignition switch OFF. |
| 6. | Disconnect the throttle body 6P connector. |
| 7. | Disconnect the throttle actuator control module 16P connector. |
| 8. | Check for continuity between throttle body 6P connector terminal No. 1 and body ground. Is there continuity? YES - Repair short in the wire between the throttle body and the throttle actuator control module (TPS A line), then go to 17. NO - Substitute a known-good throttle actuator control module, then go to 17. and recheck. If DTC P0122 is not indicated, replace the original throttle actuator control module, then go to 17. If DTC P0122 is indicated, then go to 15. |
| 9. | Measure voltage between throttle body 6P connector terminal No. 2 and body ground. Is there about 5 V? YES - Go to 15. NO - Go to 10. |
| 10. | Turn the ignition switch OFF. |
| 11. | Disconnect the throttle actuator control module 16P connector. |
| 12. | Disconnect the throttle body 6P connector. |
| 13. | Connect the throttle body 6P connector terminal No. 2 to body ground with a jumper wire. |
| 14. | Check for continuity between throttle actuator control module 16P connector terminal No. 11 and body ground. Is there continuity? YES - Substitute a known-good throttle actuator control module, then go to 17. and recheck. If DTC P0122 is not indicated, replace the original throttle actuator control module, then go to 17. If DTC P0122 is indicated, then go to 15. NO - Repair open in the wire between the throttle body and the throttle actuator control module (VCC line), then go to 17. |
| 15. | Turn the ignition switch OFF. |
| 16. | Replace the throttle body. |
| 17. | Turn the ignition switch ON (II). |
| 18. | Do the ECM/PCM RESET in the CLEAR MENU with the Honda PGM Tester or the HDS. |
| 19. | Do the ECM/PCM idle learn procedure. |
| 20. | Check for Temporary DTCs or DTCs in the DTCs MENU with the Honda PGM Tester or the HDS. Are any Temporary DTCs or DTCs indicated? YES - If DTC P0122 is indicated, check for poor connections or loose terminals at the throttle body and the throttle actuator control module, then go to 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC troubleshooting. NO - Troubleshooting is complete.n |