| 1. | Drain the engine coolant. |
| 2. | Remove the two bolts (A) securing the evaporative emission (EVAP) canister purge valve bracket and remove the bolt (B) securing the harness bracket. |
| 3. | Remove the upper radiator hose (A), heater hose (B), water bypass hose (C) and connecting pipe mounting bolt (D). |
| 4. | Disconnect the exhaust gas recirculation (EGR) valve connector (K20A6 engine). |
| 5. | Remove the water outlet/EGR passage (A). |
| 6. | Install the water outlet/EGR passage with a new gasket (B). |
| 7. | Install the other parts in the reverse order of removal. |
| 8. | Refill the radiator with engine coolant, and bleed air from the cooling system with the heater valve open. |