| DTC P0752: | Shift Solenoid Valve A Stuck ON |
| 1. | Warm up the engine to normal operating temperature (the radiator fan comes on). |
| 2. | Check to be sure that the transmission is filled to the proper level, and check for fluid leaks. |
| 3. | Check for deterioration in the quality of ATF. Has the ATF deteriorated? YES - Replace ATF, and test-drive the vehicle under the same conditions as those indicated by the freeze data, then recheck. NO - Go to 4. |
| 4. | Clear the DTC in CLEAR MENU with the Honda PGM Tester or HDS. |
| 5. | Select SHIFT SOL TEST in MISC. TEST MENU, then carry out A/T SHIFT SOL A test in SHIFT SOL TEST MENU with the Honda PGM Tester or HDS. Is a clicking sound heard? YES - Go to 6. NO - Faulty shift solenoid valve A, replace it. After replacing the shift solenoid valve, go to 8, and check that the repair has been completed. |
| 6. | Test-drive the vehicle in the [D] position in all five gears at speeds over 10 mph (16 km/h) for 20 seconds. |
| 7. | Check the OBD STATUS in DTCs MENU for a pass/fail test of code P0752. Did the result fail? YES - Repair shift valve A, or replace the transmission.n NO - Intermittent failure, the system is OK at this time. If the tester indicates NOT COMPLETE, return to step 6 and recheck.n |
| 8. | Clear the DTC in CLEAR MENU with the Honda PGM Tester or HDS. |
| 9. | Test-drive the vehicle for several minutes under the same conditions as those indicated by the freeze data. |
| 10. | Check the OBD STATUS in DTCs MENU for a pass/fail test of code P0752. Did the result pass? YES - The problem has been corrected.n NO - Return to step 1 and recheck.n |