| 1. | Remove the center console and rear console. |
| 2. | Disconnect the transmission gear selection switch/park pin switch connector. |
| 3. | Shift the shift lever into the [P] position and release the shift lever button, then check for continuity between connector terminals No. 3 and No. 4. There should be no continuity. |
| 4. | Shift out of the [P] position or press the shift lever button, and check for continuity between terminals No. 3 and No. 4. There should be continuity. |
| 5. | If the park pin switch is faulty, replace the shift lever bracket base. The park pin switch is not available separately from the shift lever bracket base. |