Torque Converter Housing Mainshaft Bearing and Oil Seal Replacement (A/T)

Torque Converter Housing Mainshaft Bearing and Oil Seal Replacement

Special Tools Required
Adjustable bearing remover set ( 07JAC-PH80000)

Handle driver ( 07749-0010000)

Driver attachment, 62 x 68 mm ( 07746-0010500)

Driver attachment, 72 x 75 mm ( 07746-0010600)

1.	Remove the mainshaft bearing and oil seal with the special tool.

2.	Install the new mainshaft bearing until it bottoms in the torque converter housing with the special tools.

3.	Install the new oil seal flush with the housing with the special tools.