A/T Shift Solenoid Valves Removal and Installation (A/T)

A/T Shift Solenoid Valves Removal and Installation

NOTE:

Do not hold the shift solenoid connector to remove and to install the shift solenoid valves. Hold the shift solenoid valve body.
Do not install the shift solenoid valve A before installing the shift solenoid valve D, and do not install shift solenoid valve B before solenoid valve E. If solenoid valves A and B are installed before solenoid valves D and E, it may damage the hydraulic control system.

1.	Remove the shift solenoid valves by holding the solenoid valve body.

2.	Install new O-rings (F) on each shift solenoid valves. NOTE: The new shift solenoid valve is equipped with new O-rings. If you install a new shift solenoid valve, there is no need to replace its O-rings.

3.	Install shift solenoid valve D by holding the shift solenoid valve body; be sure to install mounting bracket contacts the servo body.

4.	Install shift solenoid valve A by holding the shift solenoid valve body; be sure to install mounting bracket contacts the bracket on shift solenoid valve D.

5.	Install shift solenoid valve E by holding the shift solenoid valve body; be sure to install mounting bracket contacts the servo body.

6.	Install shift solenoid valve B by holding the shift solenoid valve body; be sure to install mounting bracket contacts the bracket on shift solenoid valve E.

7.	Install shift solenoid valve C by holding the shift solenoid valve body; be sure to install mounting bracket contacts the servo body.