| 1. | Remove the intake air duct. |
| 2. | Disconnect the A/T clutch pressure control solenoid valve A connector. |
| 3. | Remove the bolts securing the ATF cooler inlet line brackets (B) from the transmission hanger (C). |
| 4. | Remove the mounting bolts and the A/T clutch pressure control solenoid valve A. |
| 5. | Remove the ATF pipe (D), ATF joint pipes (E), O-rings (F), and gasket (G). |
| 6. | Clean the mounting surface and fluid passages of the A/T clutch pressure control solenoid valve A and transmission housing. |
| 7. | Install the new gasket on the transmission housing, and install the ATF pipe and ATF joint pipes. |
| 8. | Install the new O-rings over the ATF joint pipes. |
| 9. | Install the new A/T clutch pressure control solenoid valve A. |
| 10. | Secure the ATF cooler inlet line brackets with the bolts on the transmission hanger. |
| 11. | Check the A/T clutch pressure control solenoid valve A connector for rust, dirt, or oil, then connect the connector securely. |
| 12. | Install the intake air duct. |