| 1. | Disconnect the battery negative terminal, then disconnect the battery positive terminal. |
| 2. | Remove the battery hold-down bracket, then remove the battery cover, battery, and battery tray. |
| 3. | Remove the intake air duct and air cleaner housing. |
| 4. | Loosen the two bolts securing the battery base from under the vehicle, and remove the two bolts securing the battery base in the engine compartment, then remove the battery base. |
| 5. | Disconnect the connector from the 3rd clutch transmission fluid pressure switch (A), then remove the switch. |
| 6. | Make sure there is no water, oil, dust, or foreign particles inside the connector. |
| 7. | Install the 3rd clutch new transmission fluid pressure switch with a new sealing washer (B), and tighten the switch to the specified torque. |
| 8. | Connect the connector securely. |
| 9. | Install the battery base, then install the air cleaner housing and intake air duct. |
| 10. | Install the battery tray, battery, and battery cover, then secure the battery with its hold-down bracket. Connect the battery terminals. |