| DTC P2195: | A/F Sensor (Sensor 1) Signal Stuck Lean |
| 1. | Inspect the condition of the A/F sensor (Sensor 1). Is it loose in the exhaust pipe? YES - Go to 2. NO - Go to 4. |
| 2. | Turn the ignition switch OFF. |
| 3. | Reinstall the A/F sensor (Sensor 1). |
| 4. | Turn the ignition switch ON (ll). |
| 5. | Do the ECM/PCM RESET in the CLEAR MENU with the Honda PGM Tester or the HDS. |
| 6. | Do the ECM/PCM idle learn procedure. |
| 7. | Start the engine. Hold the engine speed at 3,000 rpm (min-1) with no load (in Park or neutral) until the radiator fan comes on, then let it idle for 2 minute. |
| 8. | Check for Temporary DTCs or DTCs in the DTCs MENU with the Honda PGM Tester or the HDS. Are any Temporary DTCs or DTCs indicated? YES - if DTC P2195 is indicated, check for poor connections or loose terminals at the A/F sensor (Sensor1) and the ECM/PCM, then go to 9. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC troubleshooting.n NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the A/F sensor (Sensor 1) and the ECM/PCM.n |
| 9. | Monitor the OBD STATUS for DTC P2195 in the DTCs MENU with the Honda PGM Tester or the HDS. Is it PASSED? YES - Troubleshooting is complete.n NO - If it is FAILED, check for poor connections or loose terminals at the A/F sensor (Sensor 1) and the ECM/PCM, then go to 2. If it is NOT COMPLETED, go to 4 and recheck. |