| DTC B1076: | Windshield Wiper Signal Error |
| 1. | Clear the DTCs using the Honda PGM Tester or the HDS. |
| 2. | Cycle the ignition switch to OFF and then back ON (II). |
| 3. | Turn the wiper switch to INT, LOW, then HIGH for at least 2 seconds each. |
| 4. | Check the DTCs. Is DTC B1076 indicated? YES - Go to 5. NO - Intermittent failure. The windshield wiper system is OK at this time.n |
| 5. | With the windshield wipe/washer switch OFF, select the TEST MODE MENU from the Honda PGM Tester or the HDS, and enter the DATA LIST. |
| 6. | Check the ON/OFF information of the FR WIPER BACKUP in the DATA LIST. Is the information indicator OFF? YES - Go to 7. NO - Go to 10. |
| 7. | Turn the wiper switch ON (low or high). |
| 8. | Check the ON/OFF information of the FR WIPER BACKUP in the DATA LIST. Is the information indicator ON? YES - Faulty relay control module; Replace the under-hood fuse/relay box.n NO - Go to 9. |
| 9. | Check for continuity between the No. 5 terminal of the relay module 10P connector and the No. 5 terminal of the wiper/washer switch (combination switch control unit) 8P connector. Is there continuity? YES - Faulty combination switch control unit; replace the wiper/washer switch.n NO - Repair an open in the GRN/WHT (GRN) wire.n |
| 10. | Check for continuity between the No. 5 terminal of the relay module 10P connector and body ground. Is there continuity? YES - Repair a short in the GRN/WHT wire.n NO - Faulty relay control module; Replace the under-hood fuse/relay box.n |