| DTC B1156: | Gauge Control Module Lost Communication (Wiper Switch Message) with the Combination Switch Control Unit |
| 1. | Clear the DTC using the Honda PGM Tester or the HDS. |
| 2. | Cycle the ignition switch to OFF and then back ON. |
| 3. | Check the DTCs by selecting the DTCs MENU (DTCs) from the Honda PGM Tester or the HDS. Is DTC B1156 indicated? YES - Go to 4. NO - Intermittent failure. The gauge control system is OK at this time.n |
| 4. | Check the DTCs by selecting the DTCs MENU (DTCs) of the Honda PGM Tester or the HDS. Is DTC B1009 or B1063 indicated? YES - Go to combination switch control unit input test.n |