| DTC B1281: | Windshield Wiper Switch MIST Position Circuit Malfunction |
| DTC B1283: | Windshield Wiper Switch LOW Position Circuit Malfunction |
| 1. | Clear the DTCs using the Honda PGM Tester or the HDS. |
| 2. | Cycle the ignition switch to OFF and then back ON (II). |
| 3. | Turn the windshield wiper switch in MIST and wait for 2 seconds. |
| 4. | Turn the windshield wiper switch OFF and wait for 2 seconds. |
| 5. | Turn the windshield wiper switch in INT (AUTO) and wait for 2 seconds. |
| 6. | Turn the windshield wiper switch in LOW and wait for 2 seconds. |
| 7. | Turn the windshield wiper switch in HIGH and wait for 2 seconds. |
| 8. | Check the DTCs by selecting the DTCs MENU (DTCs) from the Honda PGM Tester or the HDS. Is DTC B1281, B1282, B1283, or B1284 indicated? YES - Replace the windshield wiper/washer switch.n NO - Intermittent failure, the windshield wiper/washer switch and the combination switch control unit (LHD type) are OK at this time.n |