| 1. | Open the hood, and remove the wiper arms. NOTE: Carefuly remove the wiper arms, so that they do not touch the hood. |
| 2. | Remove the hood seal and cowl cover. |
| 3. | Disconnect the connector from the wiper motor. |
| 4. | Test the motor by connecting battery power to the No.2 terminal and ground the No. 3 [1] terminal of the wiper motor 5P connector. The motor should run at low speed. If the motor does not run or fails to run smoothly, replace the motor. |
| 5. | Test the motor by connecting battery power to the No. 2 terminal and ground the No. 5 [4] terminal of the wiper motor 5P connector. The motor should run at high speed. If the motor does not run or fails to run smoothly, replace the motor. |
| 6. | Connect an analog voltmeter between the No. 4 [5] (+) and No. 1 [3] (-) terminals, and run the motor at low or high speed. The voltmeter should indicate 12 V and 4 V or less alternately. If it does not, replace the wiper motor. [ ]: RHD type |