Door Lock Knob Switch Test - With Super Locking

Driver's Door Without Super Locking:


1.Remove the Driver's door panel.

2.Disconnect the 6P connector from the actuator.

3.Check for continuity between the terminals.

  • There should be continuity between the No. 3 and No. 4 terminals when the  door lock knob switch is in the LOCK position and no continuity when the switch is in the UNLOCK position.
  • There should be continuity between the No. 5 and No. 4 terminals when the  door lock knob switch is UNLOCK position and no continuity when the switch is in the LOCK position.

4.If the continuity is not as specified, replace the door lock actuator.

Front Passenger's Door: With Super Locking:


1.Remove the passenger's door panel.

2.Disconnect the 3P connector from the actuator.

3.Check for continuity between the terminals.

  • There should be continuity between the No. 2 and No. 3 terminals when the  door lock knob switch is in the LOCK position and no continuity when the switch is in the UNLOCK position.

4.If the continuity is not as specified, replace the door lock actuator.

Right Rear Door: With Super Locking:


1.Remove the right rear door panel.

2.Disconnect the 6P connector from the actuator.

3.Check for continuity between the terminals.

  • There should be continuity between the No. 4 and No. 5 terminals when the  door lock knob switch is in the LOCK position and no continuity when the switch is in the UNLOCK position.

4.If the continuity is not as specified, replace the door lock actuator.

Left Rear Door: With Super Locking:


1.Remove the left rear door panel.

2.Disconnect the 6P connector from the actuator.

3.Check for continuity between the terminals.

  • There should be continuity between the No. 2 and No. 3 terminals when the  door lock knob switch is in the LOCK position and no continuity when the switch is in the UNLOCK position.

4.If the continuity is not as specified, replace the door lock actuator.