| 1. | Remove the mirror holder, power mirror, and disconnect the connector. |
| 2. | Cut the wire harness (A), tube (B) with cutter, and remove the clip (C). |
| 3. | Remove the screw from the harness clip (D) and the gasket (E). |
| 4. | Remove the three screws, and separate the mirror housing (A) from the bracket (B). |
| 5. | Remove the four screws, and the visor (A). |
| 6. | Remove the one screws and separate the actuator (A) from the housing (B), and disconnect the 2P connector (C). |
| 7. | Route the wire harness of the new actuator through the hole in the bracket and gasket. |
| 8. | Install the actuator, bracket, harness clip, and gasket in the reverse order of removal. |
| 9. | Install the new actuator terminals into the connector in the orignal arrangement as shown below. |
| 10. | Cover the harness hole with a tape (A). |
| 11. | Install the clip (B). |
| 12. | Reinstall the mirror assembly to the door. |
| 13. | Operate the power mirror to ensure smooth operation. |