If the indicator displays ‘‘— — —'' for more than two seconds after selecting the outside air temperature display mode, Check the climate control system for DTCs, or an open in the LTBLU wire between the under-dash fuse/relay box and the climate conteol unit.
| 1. | Turn the ignition switch ON (II). |
| 2. | Push and hold the reset select button for 10 seconds. While you continue to hold the button, the display will scroll through temperature settings from +3° to -3° as shown. |
| 3. | When the desired correction value appears on the display, release the button, and the recalibrated outside air temperature will be displayed. NOTE: To recalibrate the display to the true temperature, remove the outside air temperature sensor (A), but leave it connected. Submerge the sensor and a thermometer (B) in a container of ice water (C). Select the calibration mode as described above, then recalibrate the display to the true temperature. |