Instrument Panel Removal/Installation

Instrument Panel Removal/Installation

NOTE:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the dashboard and related parts.
LHD is shown; RHD is symmetrical.

1.	Tilt the steering column down.

2.

Remove the instrument panel (A).

-1	Remove the screws (B).
-2	Gently pull out along the bottom to release the clips (C) and hooks (D).
-3	Gently pull out the upper portion of the panel.
-4	With auto A/C: Disconnect the in-car temperature sensor connector (E) and the air hose (F).

3.	Install the panel in the reverse order of removal. If equipped, make sure the in-car temperature sensor connector is plugged in properly, and the air hose is connected securely.