| 4. | Install the spoiler in the reverse order of removal, and note these items:
- Before installing the spoiler, fold the edge of the adhesive backing from the double-sided adhesive tape. After installing the spoiler, carefully pull the adhesive backing away, and push the spoiler into place securely.
- If the spoiler is to be reinstalled, replace the double-sided adhesive tapes as new ones:
| -1 | Remove the spacers from the spoiler. Take care not to damage them during removal.
| | -2 | Scrape off the remaining double-sided adhesive tape from the spoiler, and bumper.
| | -3 | Clean the spoiler, spacers, and bumper surfaces with a sponge dampened in alcohol where adhesive tape will be applied.
| | -4 | Apply primer (3M N-200, or equivalent) to the spacer where adhesive tape will be applied.
| | -5 | Glue the double-sided adhesive tapes (D) (3M GT7120, or equivalent) to the spoiler, and the double-sided adhesive tapes (G) (3M GT7108, or equivalent) on each side of the spacers.
| | -6 | Glue the spacers on the back surface of the front fog light openings.
|
|