| 1. | Disconnect the battery negative cable, and wait at least 3 minutes before beginning work. |
| 2. | Disconnect both seat belt tensioner connectors. |
| 3. | Remove the center console and front panel. |
| 4. | Remove the center holder. |
| 5. | Remove the center pocket. |
| 6. | Remove the driver's and passenger's center lower cover. |
| 7. | Remove the heater ducts. |
| 8. | Disconnect the connectors and remove the Torx bolts (A), then pull out the SRS unit. |
| 1. | Install the new SRS unit (A) with Torx bolts (B), then connect the connectors (C) to the SRS unit; push them into position until they click. NOTE: Be sure the SRS unit is sitting squarely against it's bracket before torquing the Torx bolt. |
| 2. | Reconnect both seat belt tensioner connectors. |
| 3. | Reconnect the battery negative cable. |
| 4. | After installing the SRS unit, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off. |
| 5. | Install all removed parts. |