| 1. | Disconnect the negative battery cable, and wait at least 3 minutes before beginning work. |
| 2. | Disconnect the driver's airbag 2P connector, the front passenger's airbag 2P connector, both seat belt tensioner 4P connectors. |
| 3. | Remove the front inner fender. |
| 4. | Disconnect the engine compartment wire harness 2P connector (A), and remove the two Torx bolts (B) using a Torx T30 bit, then remove the front impact sensor (C). |
| 1. | Install the new front sensor with new Torx bolts (A), then connect the engine compartment wire harness 2P connector (B) to the front impact sensor (C). |
| 2. | Reconnect the battery negative cable. |
| 3. | After installing the front impact sensor, confirm proper system operation: Turn the ignition switch ON (II): the SRS indicator should come on for about 6 seconds and then go off. |
| 4. | Install all removed parts. |