| 1. | Remove the rod seal from the master cylinder. |
| 2. | Remove the circlip (A) while pushing in the secondary piston (B). |
| 3. | Remove the reservoir(C). |
| 4. | On vehicle's with ABS; remove the stop pin (A) while pushing in the secondary piston (B). |
| 5. | Remove the piston guide (A), O-RING (B), retainer (C), secondary piston (D) and primary piston (E). |
| 6. | Remove the reservoir seal (A) from the reservoir cap (B). |
| 7. | Remove the strainer(C) and grommets (D) from the reservoir (E). NOTE: When reservoir and master cylinder body are separated, replace the grommets with new ones. |