| 1. | Relieve fuel pressure. |
| 2. | Remove the engine cover. |
| 3. | Disconnect the connectors from the injectors (A) and the engine mount control solenoid valve (B). |
| 4. | Remove the ground cable bolt (G101) (C). |
| 5. | Disconnect the quick-connect fittings (D). |
| 6. | Remove the fuel rail mounting nuts (E) from the fuel rail (F). |
| 7. | Remove the injector clip (G) from the injector. |
| 8. | Remove the injector from the fuel rail. |
| 9. | Coat the new O-rings (A) with clean engine oil, and insert the injectors (B) into the fuel rail (C). |
| 10. | Install the injector clip (D). |
| 11. | Coat the injector O-ring (E) with clean engine oil. |
| 12. | Install the injectors in the fuel rail first, then install the injectors in the injector base (F). |
| 13. | Install the fuel rail mounting nuts and the ground cable. |
| 14. | Connect the connectors on the injectors and the engine mount control solenoid valve. |
| 15. | Connect the quick-connect fittings. |
| 16. | Turn the ignition switch ON (II), but do not operate the starter. After the fuel pump runs for about 2 seconds, the fuel pressure in the fuel line rises. Repeat this two or three times, then check for fuel leakage. |