Special Tools Required
Handle ( 07JAB-0010200)
| 1. | Remove front tires/wheels. |
| 2. | Remove the splash shield. |
| 3. | Hold the pulley with handle (A) and holder attachment (B). |
| 4. | Remove the bolt with a 19 mm socket (C) and breaker bar. |
| 1. | Clean the crankshaft pulley (A), crankshaft (B), bolt (C), and washer (D). Lubricate as shown below. |
| 2. | Install the crankshaft pulley, and hold the pulley with handle (A) and holder attachment (B). |
| 3. | Tighten the bolt to 25 N·m 2.6 kgf·m, 19 lbf·ft) with a torque wrench and 19 mm socket (C). Do not use an impact wrench. If the crankshaft is new, tighten the bolt to 41 N·m (4.2 kgf·m, 30 lbf·ft). |
| 4. | Tighten the pully bolt an additional 90°. |
| 5. | Install the splash shield. |
| 6. | Install front tires/wheels. |